🚀 Step 1: Identify Your Card Type

Your card type and brand are crucial for selecting the correct driver.

🖥️ Step 2: Ensure Proper Hardware Setup

• Install & Power ON your DMA Card on your Main PC
• Connect your DMA Card to your 2nd PC using the JTAG port
• 📌 The JTAG port is the closest one to your motherboard

🔴 You MUST complete the DNA ID process before flashing the firmware! See here: https://perfectaim.io/help/guides/dma-dna-id-guide

🗂️ Step 3: Open "Flash Tools" Folder

Locate and open the Flash Tools folder on your system. All files and drivers can be found after purchase here: https://perfectaim.io/dma/tools/

🔹 Flashing a 35T Card

• Ensure the DMA Card is connected via JTAG port
• Rename the .bin file to: pcileech_squirrel_top.bin
• Move the renamed file into the Flash Tools folder
• Run the appropriate script based on your installed driver:
  • 🟢 If you installed "Zadig-2.5", run: #####flash_rs232_35t#####
  • 🔵 If you installed "CH341PAR", run: #####flash_ch347_35t#####
• Wait for the script to finish and confirm "Success" ✅

🔹 Flashing a 75T Card

• Ensure the DMA Card is connected via JTAG port
• Rename the .bin file to: pcileech_enigma_x1_top.bin
• Move the renamed file into the Flash Tools folder
• Run the appropriate script based on your installed driver:
  • 🟢 If you installed "Zadig-2.5", run: #####flash_rs232_75t#####
  • 🔵 If you installed "CH341PAR", run: #####flash_ch347_75t#####
• Wait for the script to finish and confirm "Success" ✅

🔄 Troubleshooting

⚠️ If you encounter errors, try these steps:

• 🔁 Re-run the script
• 📂 Ensure the file is correctly named and placed in the Flash Tools folder
• 🔌 Check that the JTAG is connected to the 2nd PC
• 🔧 Verify drivers are installed properly

🆘 Still having issues? Get help at 👉 PerfectAim.io/help

🎉 You're Done!

Credit to Kilmu for the tools!

📌 Notes

• Make sure all steps are followed exactly
• Always double-check connections, file names, and drivers before flashing
• ⚠️ Flashing incorrectly can cause issues! Proceed with caution